Új hozzászólás Aktív témák

• Kicsirics77 veterán

  #9788

  #9782 vargalex

  2014-12-16 07:13:11

  Új Válasz

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  

  Kicsirics77

  veterán

  #9782 vargalex

  governor: ondemand
  min_freq:700
  max_freq:900
  current_freq:700
  config.txt:
  # For more options and information see
  # http://www.raspberrypi.org/documentation/configuration/config-txt.md
  # Some settings may impact device functionality. See link above for details

  # uncomment if you get no picture on HDMI for a default "safe" mode
  #hdmi_safe=1

  # uncomment this if your display has a black border of unused pixels visible
  # and your display can output without overscan
  #disable_overscan=1

  # uncomment the following to adjust overscan. Use positive numbers if console
  # goes off screen, and negative if there is too much border
  #overscan_left=16
  #overscan_right=16
  #overscan_top=16
  #overscan_bottom=16

  # uncomment to force a console size. By default it will be display's size minus
  # overscan.
  #framebuffer_width=1280
  #framebuffer_height=720

  # uncomment if hdmi display is not detected and composite is being output
  #hdmi_force_hotplug=1

  # uncomment to force a specific HDMI mode (this will force VGA)
  #hdmi_group=1
  #hdmi_mode=1

  # uncomment to force a HDMI mode rather than DVI. This can make audio work in
  # DMT (computer monitor) modes
  #hdmi_drive=2

  # uncomment to increase signal to HDMI, if you have interference, blanking, or
  # no display
  #config_hdmi_boost=4

  # uncomment for composite PAL
  #sdtv_mode=2

  #uncomment to overclock the arm. 700 MHz is the default.
  arm_freq=900

  # NOOBS Auto-generated Settings:
  hdmi_force_hotplug=1
  config_hdmi_boost=4
  overscan_left=24
  overscan_right=24
  overscan_top=16
  overscan_bottom=16
  disable_overscan=0
  core_freq=250
  sdram_freq=450

Új hozzászólás Aktív témák