Új hozzászólás Aktív témák

• #3900 tusi_ addikt

  Új Válasz 2013-05-25 17:31:04 #3900

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  tusi_

  addikt

  Elakadtam 2 ponton ezzel a feladattal.

  Klikk

  All IPv4 addresses have been preconfigured for you.
  Each router has a loopback0 interface.
  Configure EIGRP AS 1 on all routers. Disable auto-summary.
  Configure EIGRP so reliability is also used as a metric.
  Make sure router Alder will use the serial 1/0 interface as the primary link.

  Itt a delay növeltem meg a FastEtherneten

  Make sure the FastEthernet0/0 interface on router Alder is a feasible successor and visible in the routing table for unequal load-balancing.

  Variance 2

  Router Walnut should send a summary route towards router Lyptus which only includes the loopback0 interfaces of router Alder, Cherry, Maple and Walnut. The summary route has to be as specific as possible.

  Erre nem tudtam mit lépni. Mi lenne az az öszefogott háló?

  The summary route you just created should show up with an administrative distance of 51 on router Walnut.

  Ip summary eig 1 xxxxxx 51

  Ensure router Alder does not send EIGRP packets towards its loopback0 interface.

  Passive interface lo 0

  Configure router Walnut so the loopback0 interface of router Lyptus will not be advertised towards router
  Cherry and Maple.

  Distribitue list X out FX/X FX/Y

  Create a default route on router Cherry and advertise it in EIGRP.

  Ip route xxxx redistr static

  Ensure only one path is used between router Walnut and Lyptus without breaking the EIGRP neighbor adjacency. You are not allowed to change the metrics.

  Maximum paths 1

  Configure the serial interface of router Alder so EIGRP is allowed only 25% the available physical bandwidth.

  Ip bandwith-percent..... 25

  Configure authentication between router Cherry and Walnut. The key-chain should be called "GNS3VAULT" and the password is "WOOD".

  key chain .......

  Router Lyptus shouldn't receive any query packets for lost networks. Configure this but make sure not to break connectivity.

  Itt vagyok elakadva megint. Ha stubot konfigolok, akkor megszakad a kapcsolat, ha summaryt, akkor viszont kap querryt, csak egy NEM-el válaszol. DE KAPNI KAP

  The serial link between router Alder and Maple will not allow multicast traffic in the future. Make the changes so the EIGRP neighbor adjacency doesn't drop when this change takes effect.

  neighbor xxxx

  Configure EIGRP on the frame relay network between router Maple, Pine and Oak. You have to configure EIGRP using the multipoint sub-interfaces. Advertise the loopback0 interfaces and ensure you have full reachability between the three routers.

  Itt a splint horizontot kell kikapcsolni a hubon.

  Erre a 2re nem jövök rá és persze ehhez nincs videó, csak a gagyi feladatokhoz

  Köszi

Új hozzászólás Aktív témák