Új hozzászólás Aktív témák

• #39517 gurabli őstag róland #39516

  Új Válasz 2015-12-10 10:48:57 #39517

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  gurabli

  őstag

  válasz róland #39516 üzenetére

  Kicsit részletesebben összefoglalva, de angolul. Ha lesz időm, akkor majd lefordítom, most sajnos nincs.

  A lényeg, hogy az Intelhez az OE EGL buildet kell használni, nem a hivatalosat, mert az hazavágja a képet (és láss csodát, legtöbb júzer teljesen elégedett azzal is, de ez normális).

  Az alábbi idézet a Kodi fórumról van, fritsch foglalta össze:

  The official OpenELEC version from http://www.openelec.tv is in no way to be compared / confused with the version in this thread.

  The builds posted here, use:

  "Passthrough 16:235" Mode by default in combination with kodi's Limited Range Setting. All Video colors are transfered untouched to the TV, which should be Limited Range. All Pictures are scaled to 16:235 range within kodi and then output without further scaling. To add, if you disable "Use Limited Range" in this kodi version, the Video data is expanded to 0..255 and banding is cared for by adding dithering. Pictures and menu are output as full rgb (0..255) and not touched. If your TV is limited range - disabling that "Use Limited range" setting makes kodi look much too dark. If your TV is full range - it should look okay - as our kernel mode does not interfer, it just lets everything you set out onto the display.

  Official OE release uses:
  A fucked up mode, called "Limited 16:235" - where the driver rescales everything it gets to 16:235 by its own while it is assuming full range input (!). So it is perfectly clear, that when you enable "Use Limited Range in kodi", that kodi scales to 16:235 but then _the driver_ does that again ... you end up with a super bright menus. For the Video output of VAAPI that does not count - as this nightmare code has blown up the Limited to full range by itself while the surfaces were copied. (Read the first post, please).

  If you run the ubuntu tutorial version without a "Passthrough 16:235" kernel - you should set the kernel to Full Range and then use kodi's setting to choose the Range as described in the first post.

  In short:
  Official OpenELEC should not be used if you care a single bit about colors ...

Új hozzászólás Aktív témák