Hirdetés
- Minimalista microATX-es ház hagyta el az In Win tervezőasztalát
- A jövő hónapban párban jönnek a Sony gaming monitorok
- A SteelSeries felfrissítette az Apex Pro sorozatú klaviatúráit
- Egységesíti a terméktámogatást az Intel?
- Kreatív hobbistáknak és profiknak szánt beviteli eszköz(pár) jött a Logitechtől
Hirdetés
-
A jövő hónapban párban jönnek a Sony gaming monitorok
ph A cég kínálata egy 1440p-s/480 Hz-es OLED és egy 4K-s/160 Hz-es IPS kijelzővel gyarapodik.
-
PlayStation Plus 2024 Essential - Az októberi lista
gp A következő hónapban többek között a Dead Space felújítását kapják meg az érdeklődők.
-
Bocsánatot kértek a globális leállást okozó szoftverhibáért
it A CrowdStrike egyik vezetője bocsánatot kért egy kongresszusi meghallgatáson, amiért egy hibás szoftverfrissítés világméretű szolgáltatáskieséseket okozott.
Új hozzászólás Aktív témák
-
Landon
őstag
Igen most néztem meg valóban nem sok difi van a két lap közt. Hát akkor attól tartok én se fogom elkerülni az áldást...
Na akkor amit olvastam:
"Does it loop if you boot it with no memory? Try it a few times, it should error, then put back in a stick and try booting again, this should clear the DMI and might get it booting again."
"Having PLL override enabled causes a MUCH bigger chance of a boot loop or a power down/power up after shutting down from windows, or changing a setting than having it disabled. It's also difficult to make an overclock setting "stick" with PLL override enabled, even at known stable settings, without getting a failed OC or one loop. This is probably why GB doesn't have it in their official bioses.
In over 30 restarts, I haven't had a single boot loop after changing bios settings (though I think BCLK change causes a power off) or after a restart from windows, with PLL override disabled."
"I have UD3P + 2500K
4.5 GHZ 1.30 vcore set in BIOS without toching other Volt stable for couple day then have restart loop symtom sometime.
4.6 GHZ 1.335 vcore no touch other volt stable for one day then have restart loop also.
4.7 G up .... have many issue with boot problem , annoying restart loop occur many time
I'm sure Cpu can go higher I ever boot at 5.0 GHZ but not stable at all.
4.8 GHZ is the best I can do stable with Prime95 1 Hr. but later It not stable. " - Uaz a problémája mint Neked uazzal a lappal.Xtremesystems-en esetleg még UD3P topic-ra próbálj rákeresni mert ez most UD4-es topicból volt.
fsb1000:Nekem is anno írogatott vmi hasonló hülyeséget vantage-nál adobe flashplayer, hogy a művelet megszakadt mert a flashplayer így meg úgy, csak arra nem emlékszem, hogy nekem is uezt a baromságot írta volna e a "lasúsággal"... De az 100%, hogy nem egyszer kaptam már ilyen üzenetet és ennek semmi köze nincs semmilyen OC-nek. Egyszerűen fos... Ha le tudod futtatni a hiba nélkül a Vntg-ot már akkor sztem ne érdekeljen.
[ Szerkesztve ]
There are no traffic jams along the extra mile.//\\Never argue with stupid people. They will drag you down to their level and beat you with experience.//
Új hozzászólás Aktív témák
- Elemzés Megateszt: Intel CPU-k Nehalemtől Skylake-ig
- Elemzés Intel Sandy Bridge teszt
- World of Tanks - MMO
- Steam Deck
- Pécs és környéke adok-veszek-beszélgetek
- Minimalista microATX-es ház hagyta el az In Win tervezőasztalát
- Elden Ring
- PlayStation 5
- A Xiaomi 14T-k már töltő nélkül érkezhetnek
- Revolut
- A fociról könnyedén, egy baráti társaságban
- Polgári repülőgép-szimulátorok
- További aktív témák...
Állásajánlatok
Cég: Ozeki Kft
Város: Debrecen
Cég: Ozeki Kft
Város: Debrecen