Hirdetés
- Versenybe hozta magát az új Xeonnal az Intel
- Titan Army P27GR monitor: hogy tud ilyen olcsó lenni?
- ATX 3.1-es Seasonic tápok a picit pénztárcabarátabb szegmensben
- Boldog-boldogtalan kézikonzolt akar kiadni, de egyelőre nincs meg a felvevőpiac
- Megszellőztették az MSI Unify-X alaplapsorozat visszatérését
- Milyen billentyűzetet vegyek?
- Apple notebookok
- Kormányok / autós szimulátorok topikja
- 2,2 kilowattos, platinás tápbestia jött a Seasonic zászlaja alatt
- Intel Core i5 / i7 / i9 "Alder Lake-Raptor Lake/Refresh" (LGA1700)
- Dell notebook topic
- NVIDIA GeForce RTX 4080 /4080S / 4090 (AD103 / 102)
- Boldog-boldogtalan kézikonzolt akar kiadni, de egyelőre nincs meg a felvevőpiac
- Házimozi belépő szinten
- Nem teljesít túl jól a kasszáknál az aktuális Xbox generáció
Hirdetés
-
GreedFall 2: The Dying World - Elindult a PC-s korai kiadás
gp A premierrel együtt kaptunk egy új rövid előzetest a játékhoz, valamint a készítők megosztották velünk a roadmapet.
-
Ismét a vietnámi OLED-gyártásba fektet a Samsung
it További 1,8 milliárd dollárt fektet be Vietnámban a Samsung az OLED-kijelzők gyártása kapcsán.
-
Akciófigyelő: Kedvezménnyel indít az új e-rolleres márka
ma Az Ausom GX1 szeptember 24-től október 7-ig kuponozható.
-
PROHARDVER!
Új hozzászólás Aktív témák
-
.mf
veterán
válasz vodkaboy22 #29595 üzenetére
Gyorsan lelomboztál
Pedig ír is valami indoklást, hogy bár szokatlan, miért működne mégis:
"Yes, the tube heater is used as a resistive load for a power MOSFET source follower. The output is then capactively coupled from there. the 19J6 heater is rated at 18.9V and 150mA. 150mA is a nice healthy current to have running in the output stage - it will drive 32 ohm headphones with ease.
In case you're wondering, yes, it's OK to put audio on the tube heaters. Think about it - normally they run on 19V RMS AC. In this case they're running on 19V DC, with a little bit of audio superimposed (rarely more than 1V or so). There could (theoretically) be a little coupling from the filament to the cathode - the cathode resistor is un-bypassed - but it would be negative feedback, and the capacitance from heater to cathode is so low compared to the cathode resistor it would probably only be measurable at RF frequencies."
Na jó, akkor nem variálok, és az a Szekeres-féle kapcsolásnál maradok, amit Bkercso is javasolt.
Ha már itt vagy, kíváncsi lennék a véleményedre a 6631A vs XMOS PCM5102-vel kapcsolatban.
Fotóim és kalandjaim a világ körül: https://www.facebook.com/fmartinphoto/
Új hozzászólás Aktív témák
Hozzászólás előtt olvasd el az összefoglalót!
A topikban terméket, munkát, szolgáltatást hirdetni tilos!
- Elemzés Erősítők tápellátása 2.
- Tudástár Parazitaeffektusok az áramkörben 1.
- Tudástár Melyik áram merre folyik a NYÁK földhálózatán?
- Tudástár Erősítők tápellátása
- Bemutató DSD: divatőrület vagy a zene új dimenziója?
Állásajánlatok
Cég: Ozeki Kft
Város: Debrecen
Cég: Ozeki Kft
Város: Debrecen